In the event of crossing a certain threshold value the solenoids will be deactivated (causing them to close). At the same time the sensor data that is now available in Labview will be used to convert to a boolean set point (on or off) for the three solenoids. This open source PLC has RS485 connectivity and all my sensors can use this protocol. The goal is to run a setup that allows a Labview UI to read out data from the sensors connected to the Arduino based PLC. 24V Arduino PLC (Controllino Maxi, based on Arduino Mega) In the end I will also upload the results if everything works so that others might profit from the experience I am new here, but I am planning on doing a project that might require a little assistance.
0 Comments
Leave a Reply. |